Are you struggling for the 3Com 3M0-600 exam? Good news,Just try Flydumps 3Com 3M0-600 exam dumps,it will help you a lot.In Flydumps new 3Com 3M0-600 vce or pdf braindump file,you can get all the 3Com 3M0-600 new questions and answers,we ensure high pass rate and money back guarantee.
QUESTION 47
Match each Radio Frequency (RF) propagation issue with its description.
A.
B.
C.
D.
Correct Answer:
QUESTION 48
Choose the three features supported by the 11g 54Mbps Wireless LAN Indoor Building-to-Building Bridge. (Choose three.)
A. Point-to-point or point-to-multipoint configurations
B. Multiple antenna options
C. Up to 108 Mbps in turbo mode
D. Wireless Distribution System (WDS) Bridging
E. Weatherproof enclosure
Correct Answer: ABD
QUESTION 49
Which antenna type is typically used indoors to provide large coverage areas within a building?
A. Patch panel or parabolic antenna
B. Dipole antenna
C. Omnipole antenna
D. Yagi or semi-directional antenna
Correct Answer: C
QUESTION 50
Which three are provided by the 3Com Wireless LAN Site Survey V2.x for discovered access points (APs)? (Choose three.)
A. Type of authentication and encryption activated on the APs
B. APs available in your area
C. VLAN ID of each AP
D. IP address of each AP
E. Channel used by each AP
F. Radio type for each AP, i.e., 802.1a/b/g
Correct Answer: BEF
QUESTION 51
What is the first step a wireless station performs as it attempts to access a wireless network?
A. Beaconing
B. Active or passive scanning
C. Roaming and reassociation
D. Authentication
Correct Answer: B QUESTION 52
To configure encryption on an access point (AP) that is part of a Wireless Distribution System (WDS), you must configure each AP separately, using a wired-Ethernet connected computer.
A. True
B. False
Correct Answer: A QUESTION 53
The 3Com Wireless LAN Controller WX4400 provides high-bandwidth, centralized control for up to 144 directly attached managed access points (MAPs).
A. True
B. False
Correct Answer: B QUESTION 54
To use IEEE 802.1X Network Login for the wireless LAN (WLAN), you must configure both the 3Com access point (AP) and wireless LAN NIC for 802.1X authentication.
A. False
B. True
Correct Answer: B QUESTION 55
Which security protocol uses a hashed password for authentication rather than using a less secure encrypted password?
A. Extensible Authentication Protocol-Message Digest 5 (EAP-MD5)
B. Wired Equivalent Privacy (WEP)
C. 3Com Dynamic Security Link
D. Temporal Key Integrity Protocol (TKIP)
Correct Answer: A QUESTION 56
What is the process for determining the best installation design of a Wireless LAN (WLAN)?
A. Facility walk-through
B. WLAN analyzer
C. Site survey
D. Network discovery
Correct Answer: C QUESTION 57
You have launched the 3Com Wireless Infrastructure Device Manager (WIDM) software to configure your Wireless LAN Access Point 8750. When you see the access point (AP) on your PC screen, it has an exclamation point located to the left of the AP. What is the significance of the exclamation point?
A. The AP is still booting up
B. The AP does not have an IP address assigned or is in a different subnet from your PC
C. The AP has had a device failure and is non-operational
D. The AP is configured as a Managed Access Point (MAP)
Correct Answer: B QUESTION 58
Which best describes the purpose of the 3Com Wireless LAN Switch Manager (3WXM) “upload” command?
A. To perform an error check on a configuration file, then load the file from a 3Com Wireless LAN Switch/ Controller to the 3WXM
B. To deploy a configuration file from 3WXM to a 3Com Wireless LAN Switch/Controller
C. To load a configuration file from a 3Com Wireless LAN Switch/Controller into 3WXM, perform an error check on the file and place the unit into the network plan
D. To perform an error check on a configuration file, then deploy the file from 3WXM to a 3Com Wireless LAN Switch/Controller
Correct Answer: C QUESTION 59
What is dynamic rate shifting on Wireless LAN (WLAN) products?
A. Wireless devices that support packet bursting to increase throughput by sending more frames per a given time period
B. Automatic Turbo mode with up to 108 Mbps
C. Ability to dynamically support both IEEE 802.11b and IEEE 802.11g speeds
D. Wireless devices that automatically change the connection speed based on the quality of the signal
Correct Answer: D QUESTION 60
What is the estimated Mbps speed achieved with an IEEE 802.11a access point at the maximum distance of 50 meters (164 feet)?
A. 12 Mbps
B. 6 Mbps
C. 2 Mbps
D. 36 Mbps
E. 54 Mbps
Correct Answer: B QUESTION 61
3Com 3M0-600 Exam Certification Guide is part of a recommended study program from 3Com 3M0-600 that includes simulation and hands-on training from authorized 3Com 3M0-600 Learning Partners and self-study products from 3Com 3M0-600.Find out more about instructor-led, e-learning, and hands-on instruction offered by authorized Cisco 350-001 Learning Partners worldwide